procedures is available in ASTM F2620, Standard Practice for Heat Fusion Joining of Polyolefin Pipe and Fittings, Annex A1. The operator should ensure that its qualified fusion procedures take into account and are adapted for all potential inclement weather conditions in which the
4.3 The socket fusion, butt fusion, and saddle fusion procedures in this practice are suitable for joining PE gas pipe and fittings, PE water pipe and fittings, and PE general purpose pipes and fittings made to PE product specifiions from organizations such as ASTM, AWWA, API, and ISO that are used in pressure, low pressure and non-pressure appliions.
ASTM F2136-08(2015) Standard test method for notched, constant ligament-stress (NCLS) test to determine slow crack growth resistance of HDPE resins or HDPE corrugated pipe ASTM F2164-13 Standard practice for field leak testing of polyethylene (PE) pressure piping systems using hydrostatic pressure
Heat Fusion Joining of Polyethylene Pipe and Fittings1 This standard is issued under the ﬁxed designation F2620; the nuer immediately following the designation indies the year of original adoption or, in the case of revision, the year of last revision.
HDPE Fusion Procedures August, 2010 3 Roth Avoid pipe that is not black in color and pipe that does not have “C” as the UV stabilization digit in the cell classifiion. Along with the correct ground loop piping, fittings must meet requirements for O.D. controlled
HDPE pipe and fittings manufacturers have approved PPI’s Generic Joining Procedures in an attempt to standardize the joining procedures of HDPE. For socket fusion, ASTM standard F1056 is referenced. DO NOT join Driscopipe 7000 or 8000 series products
D3261-16 Standard Specifiion for Butt Heat Fusion Polyethylene (PE) Plastic Fittings for Polyethylene (PE) Plastic Pipe and Tubing butt fusion fittings~ pipe fittings~ butt heat fusion~ plastic pipes~ plastic tubes~ 2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
The pipe ends are then aligned using the clamps on the fusion machine. A temperature controlled heater is installed in the machine and the pipe ends are heated according to the butt fusion standard ASTM International F2620. Once the heating criteria is met, the
Pipe system made of polypropylene for potable water supply old brand name new brand name Standard Dimension Ratio structure of pipe special features of pipe material company system fusiotherm SDR 11 aquatherm green SDR 11 S PP-R fusiotherm SDR7.4 aquatherm green SDR 7.4 …
Generic Butt Fusion Joining Procedure for Field Joining of Polyethylene Pipe TR-33 2012 105 Decker Court, Suite 825, Irving, TX 75062 Phone: 469-499-1044 Fax: 469-1063ii Contents